What problems should be paid attention to in daily maintenance of crane chain?
Cranes are large machinery, and the consequences will be serious once problems occur. Therefore, daily maintenance of cranes is very important.
The tightness of the lifting chain should be appropriate, too tight to increase power consumption, the bearing is easy to wear; too loose chain is easy to jump and off the chain. The tightness of the chain is: lifted or pressed from the middle of the chain, the center distance between the two sprockets is about 2%-3%.
There should be no skew and swing when the sprocket is installed on the shaft. In the same transmission assembly, the end faces of the two sprockets should be in the same plane. When the center distance of the sprocket is below 0.5 meters, the allowable deviation is 1 mm; when the center distance of the sprocket is above 0.5 meters, the allowable deviation is 2 Mm. But friction chains are not allowed.
When the sprocket wears seriously, the new sprocket and new chain should be replaced at the same time to ensure good meshing. It is not possible to replace new chains or sprockets alone. Otherwise, it will cause poor meshing and accelerate the wear of the new chain or new sprocket. After the sprocket tooth surface wears to a certain degree, it should be turned over in time (refer to the sprocket used for the adjustable surface). To extend the use time.
The new lifting chain is too long or elongated after use, it is difficult to adjust, the chain link can be removed according to the situation, but it must be an even number. The chain link should pass through the back of the chain, the locking piece should be inserted outside, and the opening of the locking piece should be in the opposite direction of rotation.
The lifting chain must remember to add lubricating oil in time. The lubricant must enter the matching gap between the roller and the inner sleeve in order to improve working conditions and reduce wear.
The old lifting chain can not be mixed with some new chains, otherwise it will easily cause impact in the transmission and break the chain.




