stainless steel lifting chain can adjust the length of the chain according to the lifting height of the crane. It is an essential and important device for the crane. It plays an important role in lifting the efficiency of the crane and expanding the scope of operation of the crane. So how to maintain the crane chain?
1. The sprocket shall be installed on the shaft without skew and swing. The end faces of two sprockets in the same drive assembly shall be in the same plane. When the center distance of sprockets is less than 0.5m, the allowable deviation is 1mm. When the center distance of sprockets is more than 0.5m, the allowable deviation is 2mm. However, it is not allowed to have the phenomenon of friction on the side of the sprocket teeth. If the two wheels are too large, it is easy to produce chain disconnection and accelerated wear. Pay attention to check and adjust the offset when replacing the sprocket.
2. The tightness of the lifting chain shall be appropriate, too tight increases the power consumption, the bearing is easy to wear and the chain is easy to jump and fall off. The tightness of the chain is: lift or press from the middle of the chain, and the center distance of the two sprockets is about 2% - 3%.
3. The new lifting chain is too long or elongated after use, which is difficult to adjust. The chain link can be removed according to the situation, but it must be an even number. The chain link shall pass through the back of the chain, the locking piece shall be inserted outside, and the opening of the locking piece shall face the opposite direction of rotation.
4. After the sprocket is seriously worn, replace the new sprocket and new chain at the same time to ensure good engagement. The new chain or sprocket cannot be replaced separately. Otherwise, it will cause poor engagement and accelerate the wear of new chain or sprocket. When the tooth surface of the sprocket is worn to a certain extent, it shall be turned over for use in time (refers to the sprocket with adjustable surface). To extend the use time.
5. The old lifting chain shall not be mixed with some new chains, otherwise it is easy to have impact in the transmission and break the chain.
6. The lifting chain shall be filled with lubricating oil in time during operation. The lubricating oil must enter into the fitting clearance between the roller and the inner sleeve in order to improve the working conditions and reduce the wear.




